|
Maintenance and Inspection Methods for Swivel CastersMaintenance and inspection methods for universal wheels As the core load-bearing component of carts, racks, and equipment, the performance of universal wheels directly affects the safety and service life of their use. The following are standardized maintenance and inspection methods: 1. Daily maintenance methods Cleaning and dust removal Regularly wipe the dust and sediment off the surface of the universal wheel with a dry cloth. If there is oil stain, dilute it with a neutral detergent before wiping to prevent grease and debris from infiltrating the bearing and affecting its rotation. After cleaning, use a dry cloth to dry it to prevent metal parts from rusting. Lubrication maintenance Every 1-2 months (or monthly for high-frequency usage scenarios), apply specialized lubricating oil or grease to the bearing area. Before applying, remove any impurities around the bearing to ensure that the lubricant penetrates fully. It is prohibited to use acidic or corrosive lubricants to avoid damaging the axle and wheel surface. Fastening of components Regularly inspect the connecting screws between the wheel frame and the mounting plate, and promptly tighten them if found loose to prevent the wheel frame from falling off during use. Storage protection Idle universal wheels should be stored in a dry and ventilated environment, avoiding exposure to direct sunlight, rain, or contact with acidic or alkaline substances. If the wheel surface is made of rubber, it should be kept away from sharp objects and high-temperature sources to prevent aging and cracking. II. Regular testing methods appearance inspection Inspect the wheel surface: Check for cracks, deformation, uneven wear, etc. If the rubber wheel surface exhibits cracks deeper than 2mm or wear that reaches 1/3 of the original thickness, it needs to be replaced promptly. Inspect the wheel frame: Observe whether the metal wheel frame is rusted, deformed, or has weld cracks. If any of the above issues are present, do not continue to use it. Rotational performance testing Push the universal wheel after it is loaded to feel whether it rotates smoothly, without any stagnation or abnormal noise. Under normal circumstances, it should rotate flexibly without obvious resistance; if there is any stagnation, check whether the bearing has impurities or is damaged, and replace the bearing if necessary. Load-bearing stability test Load a weight equivalent to 1.2 times the rated load capacity of the universal wheel, let it stand for 12 hours, and then inspect the wheel frame for any deformation and the axle for any bending. After unloading, test the rotation to ensure it is normal. If any abnormalities are found, it is determined that the load capacity does not meet the standard. Steering flexibility detection Operate the equipment equipped with universal wheels and test whether the 360¡ã steering is smooth. Check for any clamping or deviation during steering. If the steering resistance is too high, clean the steering structure of impurities or replace worn parts. III. Precautions Overloading is strictly prohibited as it will directly lead to axle fracture and tread damage. The maintenance priorities for universal wheels of different materials vary: nylon wheels are resistant to wear but should be handled with care to avoid falls; polyurethane wheels are resistant to oil but should be kept away from high temperatures, and should be kept away from heat sources. |